A faucet is a valve that controls the flow of water and is a common hardware accessory. Whether it's in the kitchen, bathroom, or laundry room at home, we all need to use a faucet wherever there is water. But when we replace a faucet that has been in use for a long time, it often results in improper operation due to lack of experience, resulting in the faucet breaking in the wall. So when we encounter such a difficult problem in our daily life, how should we handle it? belowGuangdong faucet manufacturerAnalyze the reason for the faucet breaking in the wall and provide specific solutions.

Why did the faucet break in the wall? After investigation, it was found that there are two main reasons for the faucet breaking in the wall:

1. It may be due to the poor quality of the accessories we purchased, coupled with the tight installation during installation. If it is one's own home decoration proposal to purchase branded products from large building materials, there will be a greater guarantee. For other devices, just make sure that they are just right. Only Thread seal tape is allowed to be used in the data, and hemp is not allowed to be used.

2. Of course, the main reason is still that we used improper force when opening the faucet. When disassembling, it is found that it is very tight. Do not use excessive force. You can apply a small amount of liquid or rust remover to the thread, and then disassemble it in an instant.

Common repair methods for broken faucets in walls:

1、 Go to the hardware store in advance to buy a guideline for cutting floor tiles to facilitate the opening of the wall. Then use a pointed pliers with your left hand to clamp a small cement nail, and use a hammer with your right hand to nail the cement nail into the joint, and it will be ready soon. The estimated time to succeed for the first time is only 30% to 40%, beginners need to be patient. You can also use a hacksaw blade to pull out a guide and then use a flat screwdriver to reverse tap and rotate it out. You can also find a saw blade to cut two opposite gaps in the pipes inside the wall. Use a steel plate with a relative width and sufficient hardness, similar to using a flat screwdriver to tighten the screws, and use pliers to remove the broken wires.

2、 The hardware store has a tool for breaking the thread extractor. If it is not available, it can be purchased online. Insert it into the broken part of the thread mouth, turn it counterclockwise, and use even force to take out the broken screw. Mix with rust remover for the fourth method: if conditions permit, re tap and make grinding tools.

It is worth noting that when repairing the faucet, one should try to remove it and not use too much force to remove it back and forth. Once loose, quickly remove it. The faucet is turned on counterclockwise! Clockwise is off! Whether it is placed upside down or horizontally. If you are unsure, still ask a water and electricity technician to handle it to avoid damaging the inner thread and causing more trouble. Suggest purchasing high-quality faucets to avoid repeating the same mistakes.

　　文章源自：Guangdong faucet manufacturer

　　http://www.yingtuweiyu.com