1、 Maintenance methods

1. First, tighten the faucet and use a pliers to rotate the faucet counterclockwise to remove it. Stainless steel faucet

2. Turn the threaded hole outward and wrap it 5-6 times clockwise with wind printed tape on the threaded part.

3. Check if the faucet has been properly adjusted and use a water bolt pliers to bolt it in clockwise direction. After the installation is completed, turn on the main switch and try to confirm if there is still water leakage.

2、 Reasons for water leakage

1. The reason for water leakage at the water outlet is due to the wear of the axial gasket inside the faucet. Use pliers to loosen and remove the gland bolt, remove the shaft gasket with a clamp, and replace it with a new shaft gasket. Stainless steel faucet

2. Reason for water leakage in the lower gap of the faucet bolt: It is caused by the wear of the triangular sealing gasket inside the gland. Be able to loosen the screws and remove the bolt head, then loosen and remove the gland, and then remove the triangular seal on the inner side of the gland and replace it with a new one.

3. Leakage at the joint of the connecting pipe: It is generally due to the loosening of the cap nut. It is possible to retighten the cap nut or replace it with a new U-shaped sealing gasket.

4. Water loss situation: Perhaps it is a water leakage situation. Due to the water stop disk of the single gun faucet getting stuck with sand and gravel, it is still necessary to find a specialized repairman to disassemble the faucet and organize it. However, if the rubber pad is damaged, it must be replaced.

Article source: Guangdong faucet manufacturer

　　http://www.yingtuweiyu.com